All About Flex: Plated Through-holes in Flexible Circuits


Reading time ( words)

There is probably no more important feature than the plated through-hole (also called via or via hole) with regard to the reliability and integrity of a flexible circuit. The through-hole provides electrical connection between insulated layers and enables electrical functionality on double-sided and multilayer flexible circuits.

There are a number of methods that a flex circuit manufacturer may use when generating a via hole.  For example, one can create through-holes on a panel with no circuit patterns defined, or one can insert the through-holes after the circuit traces have been imaged and etched. There are advantages and disadvantages for both situations, but the basics of creating a through-hole are the same.

The first step in via formation is to create a hole through the laminate. The hole can be created by mechanical drilling, laser drilling or punching. Once the hole has been drilled, an adhesive-based laminate will look similar to the diagram below:

Fig1.JPGFigure 1: Through-hole, side view.

Figure 1 depicts the case where a laminate consisting of copper foil, adhesive, dielectric, adhesive and copper foil are used. Adhesiveless laminates are also very popular and are produced with a variety of technologies that bond copper to dielectrics sans adhesive.

Electroplating is a process where metal ions are bonded to a metal surface. The process requires a voltage potential between a copper source (anode) and the plating target (copper circuit). Both the anode and copper circuit are immersed in a copper sulphate solution with an applied voltage potential. This promotes ion flow from the anode to the cathode (the circuit). Areas of a circuit panel with a voltage potential will get plated, so any part of a copper circuit that is electrically isolated will not get plated. Since copper layers are separated by dielectric materials, and there is no electrical charge going through the through-hole, electroplating between layers is not possible. In order to allow electroplating, a conductive “bridge” must be coated over the insulating layer.

The two most common methods for creating that conductive bridge are:

  • Electroless copper plating
  • Shadow plating

Share

Print


Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

01/08/2021 | Nolan Johnson, I-Connect007
It’s a new year, and time for new resolutions and new beginnings. “New year, new you” certainly is reflected in this past week’s news. We saw several announcements regarding mergers, acquisitions, and organizational changes, plus some government legislation to help kick off the new year. Based on viewing activity, readers were keen to keep up on the changes under way.

IPC CEO and President John Mitchell Discusses New Membership and Dues Structure

01/07/2021 | I-Connect007 Editorial Team
In this video, IPC CEO and President Dr. John Mitchell discusses the organization’s move from a site-based and enterprise membership dues structure to a company revenue-based model. Mitchell explains that this change will go into effect upon each member company’s renewal in 2021, and he points out that many of the existing member discounts will remain unchanged.

Whiteside’s View From the Summit: An Industry Perspective

01/04/2021 | Nolan Johnson, I-Connect007
I spoke with Shane Whiteside to get his unique perspective on the industry as president and CEO of Summit Interconnect, as well as his position on the board of directors for the IPC. Whiteside discusses the business challenges he sees overall.



Copyright © 2021 I-Connect007. All rights reserved.