Made in Brazil: The Evolution and Revolution of Impedance Control in PCB Production


Reading time ( words)

The PCB industry in Brazil has gone through several changes over the last decade. Our customers have been demanding better quality and higher-reliability products more than ever before, but few things have changed as much as impedance control. PCBs with impedance control requirements have become the engine of the market, and finding solutions to fit the customer’s needs is extremely challenging.

Ten years ago, the Brazilian PCB industry was a little vague on this subject, and very few PCB shops were doing impedance testing. About five years ago, with the evolution of the national PCB industry, customers started producing prototypes requiring impedance control and the market started to develop. However, it seemed to me that neither the customers nor the PCB shops really knew what to order and to deliver at that time.

There always were differences between the specs for the board, the coupon measured, and the simulation software. As a best practice, many PCB shops used to appeal to a cross-section analysis to verify the PCB build up. In the end, impedance simulation software was more reliable than the TDR measurements.

I remember I felt a bit normal last year when I read the article written by Dan Beaulieu and Bob Tarzwell for The PCB Design Magazine, "Controlled Impedance: A Real-World Look at the PCB Side." Coupons that don’t fit the specs of the customers, cross-section analyses, differences in resin flow during lamination, copper thickness variation, and many other issues described in the article were very similar to the problems we faced daily.

Nevertheless, the industry in Brazil has gone further, pressing the suppliers to develop new controls, not yet usual to the national market.

To read this entire article, which appeared in the July 2016 issue of The PCB Magazine, click here.

Share

Print


Suggested Items

Meet Chris Mitchell, I-Connect007 Columnist

08/14/2019 | I-Connect007
Chris Mitchell is vice president for global government affairs at IPC—Association Connecting Electronics Industries—where he is responsible for development and implementation of the organization’s global advocacy efforts and public policy agenda with a focus on electronics industry business improvement, environment, health and safety, and defense initiatives.

Crowded Congressional Calendar Affects Industry Priorities

07/24/2019 | Chris Mitchell, IPC VP, Global Government Relations
More than five months remain in 2019, but U.S. congressional leaders are already running out of time as they face a long list of must-pass bills before year’s end. Although some of these bills do not affect the electronics industry, some of them do, and the overall agenda does affect the opportunities and risks we face.

Emma Hudson: From Tomboy to Tech Lead

06/21/2019 | Gen3
In this interview, Emma Hudson, CTO of Gen3, and Gayle Paterson, founder of Female Leaders in Tech, Everywhere (FLITE), discuss careers and the electronics industry.



Copyright © 2019 I-Connect007. All rights reserved.