Heart Aerospace Selects Siemens Xcelerator for New Electric Airplane

Reading time ( words)

Electric airplane maker Heart Aerospace has selected Capital from the Siemens Xcelerator portfolio to support its E/E system design, development, and certification of zero emission electric aircraft.

Siemens Digital Industries Software announced today that Swedish electric airplane maker Heart Aerospace has selected the Capital™ software portfolio from the Siemens Xcelerator portfolio of software and services to support its design, development, and certification of zero emission electric aircraft. Siemens’ Capital will provide electrical and electronic (E/E) system design and support as Heart Aerospace addresses the market and regulatory demands of escalating performance and commercial certification requirements.

As part of the extensive electrification in these aircraft, Heart Aerospace must address the complexity of the Electrical Wiring Interconnect System (EWIS) while also addressing electrical system compliance risk. The Capital tool’s strong compliance functionality can help Heart Aerospace to leverage automation and digital data continuity to facilitate faster regulatory compliance. This was a key reason for selecting Capital software from Siemens.

“Heart Aerospace’s adoption of Capital from the Siemens Xcelerator portfolio gives them the advantage inherent in digitalized E/E system development out of the starting gate,” said Anthony Nicoli, Senior Director for Aerospace & Defense, Siemens Digital Industries Software. “To successfully compete for air transport routes, eAircraft must achieve demanding performance goals using fully certified, power and weight optimized E/E systems. Siemens is excited to help Heart Aerospace accelerate aircraft design to meet both performance and certification requirements.”

“As a young company with a new project, Heart Aerospace decided to adopt Capital software, which was the only tool we evaluated that supports creation of electrical and avionic system deliverables and seamlessly flows them downstream into the physical products of the EWIS for each development phase,” said John Rader, Section Lead Electrical Wiring Interconnect System (EWIS) Engineer, Heart Aerospace. “The improvement in workflow, especially when considering that configuration management within Capital is both strong and intuitive, allows focus on the engineering and not the tool. With sophisticated additional analysis models such as voltage drop calculation and the great support available, Heart Aerospace is confident we made the best choice.”

03/13/2023 | Boeing

Boeing and Shield AI have signed a memorandum of understanding to explore strategic collaboration in the areas of autonomous capabilities and artificial intelligence on current and future defense programs. Shield AI created Hivemind, an artificial intelligence pilot that has flown a variety of aircraft. According to Shield AI, the AI pilot can also enable swarms of drones and aircraft to operate autonomously without GPS, communications or a human pilot in the cockpit.

02/23/2023 | I-Connect007 Editorial Team

With multiple advanced degrees in aerospace science, Emily Calandrelli could have had her pick of any project in earth and space science. Instead, she has chosen to use her skills in science policy and communication to break down complex science topics, advocate for women in STEM fields, and bolster enthusiasm for the next generation of scientists through her own Netflix show and an active slate of social media accounts. Emily’s platform is huge, but it's one that she wholeheartedly embraces. In this interview with the I-Connect007 Editorial Team, Emily talks about her unconventional entry into science, what’s ahead for space commerce, advice for industry leaders, and what she really thinks about going into space.

01/24/2023 | Lee Ritchey, Speeding Edge

As the aerospace industry has been tasked with fitting increasingly complex electronics in existing airframes the demands on PCB substrates have begun to overtask the existing state of the art in PCB fabrication. Recently, I was called in to troubleshoot some reliability problems with a very dense PCB that had components on both sides and required the use of stacked blind vias and buried vias. The usual name for this kind of design is “build-up fabrication,” requiring many trips through the lamination, drilling, and plating operations at a fabricator.