Made in USA and Total Cost: Six Ways U.S. Sourcing Saves Money
November 10, 2015 | Gary Burnett, Jr. Burton Industries Inc.Estimated reading time: 1 minute
There is no question that manufacturing in countries known for lower labor costs can save money on some projects. In cases of highvolume production, selecting low-cost labor regions close to end markets can generate significant savings and in some cases, fulfill the local content requirements necessary for entry into those markets.
However, when total costs are considered, medium- and low-volume production often doesn’t benefit from working at distance, since crossing borders increases logistics costs, adds internal costs relative to team travel and adds complexity to project transfer and support.
In cases of medium- and low-volume projects, a regional U.S. contract manufacturer may represent a lower total cost than a manufacturer in a low labor cost country. Some of that cost difference is visible, but in many cases, the reduction comes from elimination of cost surprises not evident in unit price alone. Burton Industries, a regional electronics manufacturing services (EMS) provider with manufacturing located in Ironwood, Michigan, routinely sees its customers opt to keep portions of their manufacturing in the U.S. for this reason. Here are six areas where using a U.S. contract manufacturer often saves money.
- New product introduction (NPI)
- Logistics
- Quality
- Staff support time
- Production changeovers
- Responsiveness
New Product Introduction The NPI process often provides the best opportunities for removing cost from the product. Design for manufacturability and testability (DFM/DFT) is one area that can drive reduction in cost and elimination of defect opportunities. Product lifecycle management (PLM) analysis can help mitigate obsolescence risk and/or identify potential obsolescence risk early enough to provide multiple remediation options.
Editor's Note: This article originally published in the November 2015 issue of SMT Magazine.
Suggested Items
Connecting the Dots: Designing for Reality—The Pre-Manufacturing Process
05/08/2024 | Matt Stevenson -- Column: Connect the DotsI have been working with Nolan Johnson on a podcast series about designing PCBs for the reality of manufacturing. By sharing lessons learned over a long career in the PCB industry, we hope to shorten learning curves and help designers produce better boards with less hassle and rework. Episode 2 deals with the electronic pre-manufacturing process. Moving from CAD (computer-aided design) to CAM (computer-aided manufacturing) is a key step in PCB manufacturing. CAM turns digital designs into instructions that machines can use to actually build the PCB.
All Flex Solutions Hires Mike Madetzke as Manager of R&D
05/08/2024 | All Flex SolutionsAll Flex Solutions is very pleased to announce that Mike Madetzke has joined their team as their new Manager of Research and Development.
Shane Whiteside of Summit Reflects on Today's PCB Landscape
05/08/2024 | I-Connect007 Editorial TeamSummit Interconnect began as a printed circuit board manufacturing company just eight years ago and has seen impressive growth organically and through acquisition. Summit President and CEO Shane Whiteside takes a few moments to share his thoughts on the growing PCB industry in the United States.
America Projected to Triple Semiconductor Manufacturing Capacity by 2032, the Largest Rate of Growth in the World
05/08/2024 | SIAThe Semiconductor Industry Association (SIA), in partnership with the Boston Consulting Group (BCG), released a report on the global chip supply chain that projects the United States will triple its domestic semiconductor manufacturing capacity from 2022—when the CHIPS and Science Act (CHIPS) was enacted—to 2032.
Coherix Partners with EMU on 'Factory of the Future' Technology Program
05/08/2024 | PRNewswireMichigan-based Coherix is working with Eastern Michigan University (EMU) in Ypsilanti to develop "factory-of-the-future" manufacturing and assembly technology.