Robot-driven Device Improves Crouch Gait in Children with Cerebral Palsy
July 31, 2017 | Columbia EngineeringEstimated reading time: 4 minutes
In the U.S., 3.6 out of 1000 school-aged children are diagnosed with cerebral palsy (CP). Their symptoms include abnormal gait patterns which results in joint degeneration over time. Slow walking speed, reduced range of motion of the joints, small step length, large body sway, and absence of a heel strike are other difficulties that children with CP experience. A subset of these children exhibit crouch gait which is characterized by excessive flexion of the hips, knees, or ankles.
Today, a team led by Sunil Agrawal, professor of mechanical engineering and of rehabilitation and regenerative medicine at Columbia Engineering, has published a pilot study in Science Robotics that demonstrates a robotic training method that improves posture and walking in children with crouch gait by enhancing their muscle strength and coordination.
Crouch gait is caused by a combination of weak extensor muscles that do not produce adequate muscle forces to keep posture upright, coupled with tight flexor muscles that limit the joint range of motion. Among the extensor muscles, the soleus, a muscle that runs from just below the knee to the heel, plays an important role in preventing knee collapse during the middle of the stance phase when the foot is on the ground. Critical to standing and walking, the soleus muscle keeps the shank upright during the mid-stance phase of the gait to facilitate extension of the knee. It also provides propulsive forces on the body during the late-stance phase of the gait cycle.
“One of the major reasons for crouch gait is weakness in soleus muscles,” says Agrawal, who is also a member of the Data Science Institute. “We hypothesized that walking with a downward pelvic pull would strengthen extensor muscles, especially the soleus, against the applied downward pull and would improve muscle coordination during walking. We took an approach opposite to conventional therapy with these children: instead of partial body weight suspension during treadmill walking, we trained participants to walk with a force augmentation.”
Video showing how the robot-driven TPAD training method works to improve crouch gait in children with cerebral palsy:
Video courtesy of Sunil Agrawal/Columbia Engineering
The research group knew that the soleus, the major weight-bearing muscle during single stance support, is activated more strongly among the lower leg muscles when more weight is added to the human body during gait. They reasoned that strengthening the soleus might help children with crouch gait to stand and walk more easily.
To test their hypothesis, the team used a robotic system—Tethered Pelvic Assist Device (TPAD)—invented in Agrawal’s Robotics and Rehabilitation (ROAR) Laboratory. The TPAD is a wearable, lightweight cable-driven robot that can be programmed to provide forces on the pelvis in a desired direction as a subject walks on a treadmill. The researchers worked with six children diagnosed with CP and exhibiting crouch gait for fifteen 16-minute training sessions over a duration of six weeks. While the children walked on treadmills, they wore the TPAD as a lightweight pelvic belt to which several wires were attached. The tension in each TPAD wire was controlled in real time by a motor placed on a stationary frame around the treadmill, based on real-time motion capture data from cameras. The researchers programmed the TPAD to apply an additional downward force through the center of the pelvis to intensively retrain the activity of the soleus muscles. They used a downward force equivalent to 10 percent of body weight, based on the results of healthy children carrying backpacks. This was the minimum weight needed to show notable changes in posture or gait during walking.
“TPAD is a unique device because it applies external forces on the human body during walking,” says Jiyeon Kang, PhD candidate and lead author of the paper. “The training with this device is distinctive because it does not add mass/inertia to the human body during walking.”
Video showing how the robot-driven TPAD training method works to improve crouch gait in children with cerebral palsy:
Video courtesy of Sunil Agrawal/Columbia Engineering
The team examined the children’s muscle strength and coordination using electromyography data from the first and last sessions of training and also monitored kinematics and ground reaction forces continuously throughout the training. They found that their training was effective; it both enhanced the children’s upright posture and improved their muscle coordination. In addition, their walking features, including step length, range of motion of the lower limb angles, toe clearance, and heel-to-toe pattern, improved.
“Currently, there is no well-established physical therapy or strengthening exercise for the treatment of crouch gait,” Agrawal notes.
Heakyung Kim, A. David Gurewitsch Professor of Rehabilitation and Regenerative Medicine and Professor of Pediatrics at the Columbia University Medical Center, who treats these patients, added “Feedback from the parents and children involved in this study was consistent. They reported improved posture, stronger legs, and faster walking speed, and our measurements bear that out. We think that our robotic TPAD training with downward pelvic pull could be a very promising intervention for these children.”
The researchers are planning more clinical trials, to test a larger group and changing more variables. They are also considering studying children with hemiplegic/quadriplegic CP.
Suggested Items
I-Connect007 Editor’s Choice: Five Must-Reads for the Week
12/06/2024 | Marcy LaRont, I-Connect007This week’s must-reads include a discussion on innovation and embedded components within the layers of a PCB with Accurate Circuit Engineering. We revisit the real cost to manufacture in a case study on how a seemingly small design error can have a dramatic effect on your end customer’s costs. Dan Beaulieu provides this month’s book review highlighting the criticality of fostering creativity in the workplace. Bert Horner of The Test Connection discusses his decision to launch a new, complimentary business venture, The Training Connection; and Ramon Roche of NCAB talks about electric vehicle charging.
The Training Connection Difference
12/04/2024 | Andy Shaughnessy, I-Connect007Bert Horner, president of The Test Connection, has recently launched The Training Connection, a new company that addresses critical training needs in test engineering and development. With a focus on essential methodologies like design for test (DFT) and IPC standards, the initiative promises to enhance the skills of professionals in the field. At PCB Carolina, Bert talked about the program, its positive reception, and the growing demand for practical, effective training solutions within the industry.
Rheinmetall, Hologate Sign Strategic Cooperation
12/03/2024 | RheinmetallDüsseldorf-based Rheinmetall AG, a leading company in the field of defense and security technologies, and Hologate, the world's leading provider of sophisticated Extended Reality (XR) solutions in the field of simulation and entertainment, intend to work closely together in the future to develop innovative simulation solutions.
Virginia is for (PCB) Lovers: Weidmuller USA Celebrating 50 Years in Virginia
11/18/2024 | Linda Stepanich, IPCThe Weidmuller Group, a provider of Smart Industrial Connectivity products and solutions, is a family-owned company founded in 1850 in Germany. It currently operates sites in more than 80 countries. Weidmuller USA, based in Richmond, Virginia, and celebrating 50 years in 2025, plans to open an engineering and production facility this fall, bringing more jobs to the region.
Real Time with... SMTAI 2024: Coating Solutions for Every Size from ECT
11/07/2024 | Real Time with...SMTAIErick Campos reviews the one-stop coatings solutions offered by ECT, ranging from coating services to equipment installation and training.