MivaTek Installs Two LED Direct Imaging Systems


Reading time ( words)

MivaTek Global’s Vice President of Business Development, Chris Hrusovsky, is pleased to announce the company installed two additional Miva LED Direct Imaging Systems in June. Hrusovsky commented, “One of our installations included a 2400DT Dual Tray System to a PCB customer in South China. This company installed their second Miva DI machine for processing solder mask in high volumes on rigid-flex panels. Our Chinese Partner, WKK, assisted our own technical engineer with the installation.” 

The company also installed a 2000L machine, their 38th operating LED DI system in North America, to a customer in the Midwest for imaging inner and outer layer dry films, as well as solder mask panels. Hrusovsky added, “We also reached a milestone by accepting our 40th direct imaging machine order for a customer in the South Eastern United States. This sale was completed with our partner Photo Chemical Solutions.”

Share

Print


Suggested Items

Future Trends in Flying Probe Testing

11/29/2019 | I-Connect007 Editorial Team
Peter Brandt, director of sales for Europe and Japan at atg, sits down with Pete Starkey and Barry Matties, gives his views on market requirements and testing technologies, and explains how flying probe testing is becoming the industry standard at all levels of production—and in many cases, the only practicable solution.

Decreasing Bend Radius and Improving Reliability- Part II

11/22/2019 | Kelsey Smith, All Flex
Many of the issues that arise when using a flex circuit come from a lack of knowledge about how to properly design one, especially when the circuit is required to bend. Many novices will design a circuit that calls for bending the flex in too tight of a bend radius, which can cause damage to the circuit and lower the reliability of the end product. This series of articles will focus on the seven key aspects to consider when designing for maximum durability and maximum “flexibility”.

Solder Mask Tack Dry

11/08/2019 | Nikolaus Schubkegel
As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.



Copyright © 2019 I-Connect007. All rights reserved.