Benefits of Low-Temp Soldering: I-007eBook Now Available


Reading time ( words)

Tired of solder joint failures? Get your head off the pillow! Learn about opportunities and solutions provided by low-temperature soldering in I-Connect007’s newest micro eBook: The Printed Circuit Assembler’s Guide to… Low-Temperature Soldering.

The Printed Circuit Assembler’s Guide to… is an ongoing book series specifically dedicated to educating PCB assemblers and serves as a go-to resource for essential assembly topics.

Written by Morgana Ribas and other expert authors from Alpha Assembly Solutions, this book provides an introduction to the evolution of modern low-temperature soldering, illustrates the importance of chemistry when developing low-temperature solders, and discusses advanced and emerging applications where lower melting point alloys can provide unique assembly solutions.

“Due to the recent burgeoning in the use of low-temperature solders within the electronics assembly industry, much has been written about bismuth- and tin-based solders and solder pastes. This book does a good job of distilling out the chaff and focusing on the most relevant, valuable information available,” says Raiyo Aspandiar, senior engineer at Intel Corporation.

Readers will learn the benefits low-temperature alloys have to offer, such as reducing costs, creating more reliable solder joints, and overcoming design limitations with traditional alloys.

Download your free copy today! You can also view other titles in our full library.

We hope you enjoy The Printed Circuit Assembler’s Guide to… Low-Temperature Soldering.

For more information, contact:

Barb Hockaday
I-007eBooks

+1-916-365-1727 (GMT-8)

Share

Print


Suggested Items

Solder Mask Tack Dry

11/08/2019 | Nikolaus Schubkegel
As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.

Communication, Part 4: The Top 5 Causes of Engineering Delays

10/25/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.

New High-speed 3D Surface Imaging Technology in Electronics Manufacturing Applications

10/09/2019 | Juha Saily, Focalspec Inc.
Line confocal sensors—and scanners based on them—are used in the imaging of surfaces, transparent materials, and multi-layered structures in various metrology and inspection applications on discrete parts, assemblies, webs, and other continuous products. Line confocal sensors operate at high speed and can be used to scan fast-moving surfaces in real-time as well as stationary product samples in the laboratory.



Copyright © 2019 I-Connect007. All rights reserved.