SEHO to Exhibit at SMTA Dallas and Houston Expos


Reading time ( words)

SEHO North America, Inc. plans to exhibit at the SMTA Dallas and Houston Expo & Tech Forums. The Dallas Expo is scheduled to take place Tuesday, March 19, 2019 at the Plano Event Center, and the Houston Expo will be held Thursday, March 21, 2019 at the Stafford Centre. The company will discuss the PowerWave N2, ideally suited for medium to large production series. The system offers remarkable performance at simultaneously low investment costs.

The PowerWave N2 features an innovative fluxer unit that reduces flux consumption remarkably and creates low maintenance requirements. The spray fluxer with HVLP technology (high-volume – low pressure) ensures a stable spray jet and a very precise spray pattern even at the outer edges of the printed circuit boards (PCBs). This allows a reproducible fluxing process. Additionally, alcohol-based as well as water-based fluxes can be processed without any problems.

The flexible preheating zone configuration with an active length of 1800mm (70.86") enables the system to be customized to specific production needs. Depending on the requirements, the PowerWave N2 may be equipped with infrared heating zones, immediately reacting quartz emitters, or with convection heating modules.

Share

Print


Suggested Items

Ralf Wagenfuehr on Developing Rehm Thermal Systems' RDS Semico Oven

05/01/2019 | Barry Matties, I-Connect007
Ralf Wagenfuehr, plant manager of Rehm Thermal Systems, describes Rehm's new oven—the RDS Semico—and gives an in-depth analysis about how it was designed specifically with the semiconductor industry in mind. Ralf also discusses the semiconductor industry as a whole and outlines the company’s desire to gain market share in Taiwan and Korea in the upcoming year.

Tips & Tricks: Water Contamination and Flux Expiry

04/17/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Solder joints that form properly are not expected to exhibit reduced reliability. However, a higher number of defects created tends to lead to a higher chance that defective connections escape detection through inspection and functional testing, and that’s not a risk to be taken lightly.

Bill Cardoso Discusses Creative Electron’s Inspection Strategy

04/03/2019 | Tim Haag and Barry Matties, I-Connect007
At PCB West in Santa Clara, California, Dr. Bill Cardoso of Creative Electron held a class on advanced packaging and X-ray inspection strategy. Guest Editor Tim Haag and Publisher Barry Matties met with Bill to further discuss his class and the importance of turning inspection data into information.



Copyright © 2019 I-Connect007. All rights reserved.