Additive Electronics: Real-world Applications


Reading time ( words)

What types of applications are discussing or adopting this new PCB technology? 

  • Wearable technology
  • Military/aerospace
  • Unusual shapes and 3D products

Tara Dunn, Omni PCB president and conference co-chair, says, “Applications that need extremely thin copper, are concerned with space and weight, and have complex pin-outs, pushing the capabilities of traditional PCB manufacturing, could utilize SAP or mSAP technology. If you’re not using this kind of technology now, the chances are good that you will be soon.” Tara will also be attending and moderating a panel discussion at the conference.

Find the techniques that are right for your products at the SMTA Additive Electronics Conference on October 24, 2019.

Share

Print


Suggested Items

Communication, Part 4: The Top 5 Causes of Engineering Delays

10/25/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.

Why Designers Need to Be at the SMTA Additive Electronics Conference

10/18/2019 | I-Connect007
In a recent interview, Kelly Dack and Tara Dunn (Omni PCB president and conference co-chair) discussed why designers need to attend the SMTA Additive Electronics Conference. Tara will also be attending and moderating a panel discussion at the conference.

Additive Electronics Conference Set for October 2019 Debut

10/15/2019 | Kelly Dack
Kelly Dack and Tara Dunn talk about the upcoming conference "Additive Electronics: PCB Scale to IC Scale" on October 24, 2019, hosted by SMTA in San Jose, California, and why it's an important event for people to attend—especially those involved in the design process.



Copyright © 2019 I-Connect007. All rights reserved.