Printed Circuits Installs New Notion n.jet Direct Solder Mask and Legend Printer

Reading time ( words)

Rigid-flex circuit board manufacturer Printed Circuits has purchased and will install a new Notion Systems n.jet direct solder mask and legend ink printer.

Printing solder mask and legend ink directly onto rigid flex printed circuit boards eliminates process steps, accelerates productivity, improves accuracy and solder mask dam integrity.  Direct printing is the next generation technology for manufacturing advanced printed circuit boards. The machine also offers four point alignment to accurately align the mask to dimensional changes, such as offset, or rotation or even for trapezoidal distortion – critical capabilities for rigid flex designs. The machine is also capable of printing nomenclature with sequential serialization as well as bar code and QR code marking capabilities.

“We are very excited to bring this new technology in house,” said Matt Tannehill, Printed Circuit’s executive vice president. “Direct printing of solder mask is a terrific improvement for us, it eliminates five process steps compared to the way we have been printing mask, it is 100% additive with no waste or mess, and each pass takes 38 seconds. One panel, with solder mask and nomenclature on both sides, can be done in less than three minutes. This will give our customers a much better product, at a higher quality, while increasing our productivity in a much smaller footprint."

“We are delighted to partner with Printed Circuits in the introduction of direct additive printing to add to their capabilities,” said Peter Walshe, PCB executive director at Notion Systems GmbH. “The n.jet solder mask comes from a high accuracy and repeatability engineering background and offers numerous radical advances for PCB printing, including a unique vacuum hold down table to ensure the resist is only ever printed where it is required. Printed Circuits also had a wide range of optional extras in choosing their machine.”

About Printed Circuits

Printed Circuits is a US manufacturer of multilayer flex and rigid-flex printed circuit boards with over 40 years of experience building circuits typically used in high reliability applications such as medical, military and commercial electronics where customers place a premium on reliability, package density, and weight. For more information, visit us at printedcircuits.com.                                   

About Notion systems GmbH

Notion System is the future of mass production additive manufacturing. The n.jet inkjet platform from Notion Systems is used by customers to produce printed circuit boards, OLED & QLED displays, sensors and high quality 3D parts. Notion Systems relies on decades of experience of their staff in bringing precise inkjet systems to customers and scaling up digital printing processes for functional material.

11/08/2019 | Nikolaus Schubkegel

As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.

10/25/2019 | Steve Williams, The Right Approach Consulting LLC

In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.

10/09/2019 | Juha Saily, Focalspec Inc.

Line confocal sensors—and scanners based on them—are used in the imaging of surfaces, transparent materials, and multi-layered structures in various metrology and inspection applications on discrete parts, assemblies, webs, and other continuous products. Line confocal sensors operate at high speed and can be used to scan fast-moving surfaces in real-time as well as stationary product samples in the laboratory.