It’s Only Common Sense: When the Cheapest Board Becomes the Most Expensive
The Chemical Connection: Employee and Operator Empowerment in the Age of AI
The Big Picture: Not One, But Three Grey Rhinos
Engineered Material Systems, Inc. (EMS) announces the introduction of its new CA-150 Series Snap Cure, Low Cost Conductive Adhesive for stringing and shingling crystalline silicon and heterojunction solar modules. The CA-150 Series will be shown for the first time at the EU PVSEC Photovoltaic Exhibition, scheduled to take place September 25-28, 2017 in Amsterdam, The Netherlands.
The EMS CA-150 Series is designed for use in modified ribbon stringers. The material will snap cure and fixture cells and ribbons in seconds at 150°C with enough strength to withstand module manufacturing processes until the adhesive cure is completed during the encapsulant lamination process. EMS CA-150 series conductive adhesives can be dispensed by time-pressure, auger or jetting. The adhesive is more stress absorbing than solder to withstand the rigors of thermal cycling and processes at lower temperature than solder. CA-150 series conductive adhesives are less than half the cost of silver-filled conductive adhesives.
About Engineered Material Systems
Engineered Materials Systems, Inc. (EMS) technology focus is on electronic materials for semiconductor, circuit assembly, photovoltaic, printer head, camera module, disk drive and photonics assembly product lines. The company creates continual improvements that will guide its customers into the future. For more information, click here.
