Taiflex Scientific Posts Lower October Revenues
November 6, 2018 | Stephen Las Marias, I-Connect007Estimated reading time: Less than a minute
Taiflex Scientific Co. Ltd, a Taiwan-based supplier of flexible copper-clad laminates (FCCL) and PV module backsheets, has posted consolidated revenue of NT$919 million ($29.86 million) for October, down by 3.7% from the previous month and by 8.3% year-on-year. For January to October, total sales reached NT$8.152 billion ($264.79 million), down by 12.5% compared with the same period last year.
Revenue for the Electronic Materials (EM) business totaled NT$853 million ($27.7 million), slightly down by 0.72 month-on-month, but up by 16.9% year-on-year. For the PV segment, revenue reached NT$51 million ($1.66 million), down by 34% on-month and by 80.7% on-year.
Suggested Items
MKS’ Atotech to Participate in ECTC
05/10/2024 | MKS’ AtotechAt this year’s 74th IEEE Electronic Components and Technology Conference (ECTC), MKS’ Atotech will present and demonstrate its latest product and service innovations.
The Chemical Connection: Reducing Etch System Water Usage, Part 2
05/02/2024 | Don Ball -- Column: The Chemical ConnectionIn my last column, I reviewed some relatively simple ways to reduce water usage in existing etch systems: cutting down cooling coil water flow, adding chillers to replace plant water for cooling, lowering flow rate nozzles for rinses, etc. This month, I’ll continue with more ways to control water usage in your etcher. Most of these are not easily retrofittable to existing equipment but should be given serious consideration when new equipment is contemplated. With the right combination of add-ons, it is possible to bring the amount of water used in an etch system to almost zero.
Designer’s Notebook: What Designers Need to Know About Manufacturing, Part 2
04/24/2024 | Vern Solberg -- Column: Designer's NotebookThe printed circuit board (PCB) is the primary base element for providing the interconnect platform for mounting and electrically joining electronic components. When assessing PCB design complexity, first consider the component area and board area ratio. If the surface area for the component interface is restricted, it may justify adopting multilayer or multilayer sequential buildup (SBU) PCB fabrication to enable a more efficient sub-surface circuit interconnect.
Insulectro’s 'Storekeepers' Extend Their Welcome to Technology Village at IPC APEX EXPO
04/03/2024 | InsulectroInsulectro, the largest distributor of materials for use in the manufacture of PCBs and printed electronics, welcomes attendees to its TECHNOLOGY VILLAGE during this year’s IPC APEX EXPO at the Anaheim Convention Center, April 9-11, 2024.
ENNOVI Introduces a New Flexible Circuit Production Process for Low Voltage Connectivity in EV Battery Cell Contacting Systems
04/03/2024 | PRNewswireENNOVI, a mobility electrification solutions partner, introduces a more advanced and sustainable way of producing flexible circuits for low voltage signals in electric vehicle (EV) battery cell contacting systems.
Copyright © 2024 I-Connect007 | IPC Publishing Group Inc. All rights reserved.
Log in