SLAC Develops Novel Compact Antenna for Communicating Where Radios Fail
April 12, 2019 | SLAC National Accelerator LaboratoryEstimated reading time: 3 minutes
A new type of pocket-sized antenna, developed at the Department of Energy’s SLAC National Accelerator Laboratory, could enable mobile communication in situations where conventional radios don’t work, such as under water, through the ground and over very long distances through air.
Image Caption: A new type of pocket-sized antenna, developed at SLAC, could enable mobile communication in situations where conventional radios don’t work, such as under water, through the ground and over very long distances through air. (Greg Stewart/SLAC National Accelerator Laboratory)
The device emits very low frequency (VLF) radiation with wavelengths of tens to hundreds of miles. These waves travel long distances beyond the horizon and can penetrate environments that would block radio waves with shorter wavelengths. While today’s most powerful VLF technology requires gigantic emitters, this antenna is only four inches tall, so it could potentially be used for tasks that demand high mobility, including rescue and defense missions.
“Our device is also hundreds of times more efficient and can transmit data faster than previous devices of comparable size,” said SLAC’s Mark Kemp, the project’s principal investigator. “Its performance pushes the limits of what’s technologically possible and puts portable VLF applications, like sending short text messages in challenging situations, within reach.”
A Sizable Challenge
In modern telecommunications, radio waves transport information through air for radio broadcasts, radar and navigation systems and other applications. But shorter-wavelength radio waves have their limits: The signal they transmit becomes weak over very long distances, can’t travel through water and is easily blocked by layers of rock.
In contrast, the longer wavelength of VLF radiation allows it to travel hundreds of feet through ground and water and thousands of miles beyond the horizon through air.
However, VLF technology also comes with major challenges. An antenna is most efficient when its size is comparable to the wavelength it emits; VLF’s long wavelength requires enormous antenna arrays that stretch for miles. Smaller VLF transmitters are much less efficient and can weigh hundreds of pounds, limiting their intended use as mobile devices. Another challenge is the low bandwidth of VLF communication, which limits the amount of data it can transmit.
A new compact antenna for very low frequency (VLF) transmissions, developed and tested at SLAC, consists of a 4-inch-long piezoelectric crystal (clear rod at center) that generates VLF radiation. (Dawn Harmer/SLAC National Accelerator Laboratory)
The new antenna was designed with these issues in mind. Its compact size could make it possible to build transmitters that weigh only a few pounds. In tests that sent signals from the transmitter to a receiver 100 feet away, the researchers demonstrated that their device produced VLF radiation 300 times more efficiently than previous compact antennas and transmitted data with almost 100 times greater bandwidth.
“There are many exciting potential applications for the technology,” Kemp said. “Our device is optimized for long-range communication through air, and our research is looking at the fundamental science behind the method to find ways to further enhance its capabilities.”
Page 1 of 2
Subscribe
Stay ahead of the technologies shaping the future of electronics with our latest newsletter, Advanced Electronics Packaging Digest. Get expert insights on advanced packaging, materials, and system-level innovation, delivered straight to your inbox.
Subscribe now to stay informed, competitive, and connected.
Suggested Items
Designing Without a Rulebook: When Engineering Becomes Innovation
05/05/2026 | Stephen V. Chavez, Siemens EDAWhat if the very rules that made you successful as a PCB designer are the ones now holding you back? This reminds me of walking the floor and attending sessions at both PCB West 2025 and APEX EXPO 2026, where one common theme stood out: More designs with traditional PCB “best practices” simply don’t apply. It’s not because they’re wrong, but because the problems we’re solving have fundamentally changed. In some cases, those best practices can actually limit performance. This is where PCB design moves beyond optimization and into something far more challenging: designing without a rulebook.
ASC’s John Johnson Bullish on the U.S. and High-tech PCBs
04/28/2026 | Marcy LaRont, I-Connect007It was a good couple of days at the SMTA UHDI Symposium in Avondale, Arizona, in early April, where John Johnson, head of technology at American Standard Circuits (ASC) and resident PCB expert on UHDI in the real-world of manufacturing, was a presenter. As the symposium ended, I visited with John, who reflected on what he considered most important and what had made the greatest impression on him.
Wire Harness Taking a Step in the Right Direction
04/08/2026 | Nolan Johnson, SMT007 MagazineTo fully understand the modernization of wire harness design and assembly, we met with members of the Innovation Advisory Team for the Wire Harness Manufacturer’s Association (WHMA) to outline the current challenges facing wire harnesses and the specific steps to implement a digital data flow from OEM to manufacturer and back. In some ways, the wire harness industry is moving from 19th-century to 21st-century technology. But in the meantime, the real challenge isn’t building the harness—manufacturers are very good at that.
Lockheed Martin Ships 2nd Aegis Vessel Set with AN/SPY-7 Radar to Japan
03/16/2026 | Lockheed MartinLockheed Martin, successfully delivered the second Aegis System Equipped Vessel (ASEV) shipset of AN/SPY-7(V)1 radar equipment to the Japan Ministry of Defense (JMOD).
Marcy’s Musings: Our Own March Madness
03/18/2026 | Marcy LaRont -- Column: Marcy's MusingsI spend a lot of time looking ahead, whether that's toward future technology, market needs, or even the future of my editorial calendar. The industry is looking ahead as well. Every year at APEX EXPO, for example, participants get a clearer look at where we’re headed over the next three to five years. In fact, as our March issue is published, we will be in the throes of another great show (our own version of March Madness).