The Government Circuit: News on Defense Electronics, Europe, and Sustainability
American Made Advocacy: Taking the Fight to Capitol Hill
Defense Speak Interpreted: SWaPing Nanosatellites for Defense Systems
Karl's Tech Talk: Green Legislation and the Impact on Electronic Materials and Processes
April 5, 2016 | Karl Dietz, Karl Dietz Consulting LLCEstimated reading time: 1 minute
In a previous Tech Talk, I pointed out that “green” and “environmentally friendly” are illdefined terms. In general, these terms refer to manufacturing that involves the replacement of toxic substances with less toxic materials, the elimination of materials or processing steps, less consumption of chemicals (i.e., more efficient or higher yield processing), reduction of water use, reduction of energy use, less space requirement (i.e., smaller equipment footprint), recycling, and on-site recovery of materials. The following list highlights critical regulations that impact electronic manufacturing. A. An overview of regulations that impact materials and processes used in the fabrication of electronic devices.
RoHS: The RoHS Directive stands for “the restriction of the use of certain hazardous substances in electrical and electronic equipment.” This directive bans the placing on the EU market of new electrical and electronic equipment containing more than agreed levels of lead, cadmium, mercury, hexavalent chromium, polybrominated biphenyl (PBB) and polybrominated diphenyl ether (PBDE) flame retardants. Manufacturers need to understand the requirements of RoHS to ensure that their products, and their components, comply.
WEEE: Directive 2002/96/EC of the European Parliament and of the Council of 27 January 2003 on waste electrical and electronic equipment (WEEE). This regulation addresses the disposal and recycling of electronic equipment.
REACH: Regulation (EC) No 1907/2006 of the European Parliament and of the Council of 18. December 2006 concerning the Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH)
Editor's Note: This article originally appeared in the March 2016 issue of The PCB Magazine.
Share on:
Suggested Items
Intervala Hosts Employee Car and Motorcycle Show, Benefit Nonprofits
08/27/2024 | IntervalaIntervala hosted an employee car and motorcycle show, aptly named the Vala-Cruise and it was a roaring success! Employees had the chance to show off their prized wheels, and it was incredible to see the variety and passion on display.
KIC Honored with IPC Recognition for 25 Years of Membership and Contributions to Electronics Manufacturing Industry
06/24/2024 | KICKIC, a renowned pioneer in thermal process and temperature measurement solutions for electronics manufacturing, is proud to announce that it has been recognized by IPC for 25 years of membership and significant contributions to electronics manufacturing.
Boeing Starliner Spacecraft Completes Successful Crewed Docking with International Space Station
06/07/2024 | BoeingNASA astronauts Barry "Butch" Wilmore and Sunita "Suni" Williams successfully docked Boeing's Starliner spacecraft to the International Space Station (ISS), about 26 hours after launching from Cape Canaveral Space Force Station.
KIC’s Miles Moreau to Present Profiling Basics and Best Practices at SMTA Wisconsin Chapter PCBA Profile Workshop
01/25/2024 | KICKIC, a renowned pioneer in thermal process and temperature measurement solutions for electronics manufacturing, announces that Miles Moreau, General Manager, will be a featured speaker at the SMTA Wisconsin Chapter In-Person PCBA Profile Workshop.
The Drive Toward UHDI and Substrates
09/20/2023 | I-Connect007 Editorial TeamPanasonic’s Darren Hitchcock spoke with the I-Connect007 Editorial Team on the complexities of moving toward ultra HDI manufacturing. As we learn in this conversation, the number of shifting constraints relative to traditional PCB fabrication is quite large and can sometimes conflict with each other.