Argonne Technology Puts Solar Power to Work All Night Long
September 19, 2016 | Argonne National LaboratoryEstimated reading time: 3 minutes
Energy storage is crucial for taking full advantage of solar power, which otherwise suffers interruptions from cloudy skies and nightfall. In the past few years, concentrating solar power plants have begun producing additional electricity at night and during peak demand periods by using stored heat energy to propel a steam turbine.
Current thermal energy storage systems rely on materials that store less energy per kilogram, requiring more material at a greater cost to meet energy storage requirements.
Now, researchers at the U.S. Department of Energy’s (DOE’s) Argonne National Laboratory have designed an inexpensive thermal energy storage system that will be significantly smaller and perform more than 20 times better than current thermal systems.
With funding from DOE’s SunShot Initiative, the Argonne team is building a pilot-scale prototype of their high-efficiency latent heat thermal energy storage system (LHTES) for testing. The SunShot Initiative is a national collaborative effort to make unsubsidized solar energy cost-competitive with other forms of electricity production by 2020.
Argonne’s thermal energy storage system relies on a “phase-change” material that melts as it stores thermal energy and releases energy as it re-freezes — similar to the charge-discharge cycle in a battery.
Inexpensive salts like rock salt (sodium chloride) can be used as phase-change materials, but their use in existing thermal storage systems is limited because of the poor thermal conductivity of the salts.
However, the Argonne LHTES system drastically improves the conductivity of these salts by integrating them with a high-conductivity graphite foam. This combination reduces the overall amount of material needed to build the system and its cost, while making the thermal energy transfer significantly more efficient and still providing up to 8 to 12 hours of energy storage — a typical night of storage for a concentrating solar power plant.
“Phase-change materials tend to have low conductivity but meet the heat energy storage requirements,” said Dileep Singh, leader of Argonne’s Thermal-Mechanical Technologies group. “High-conductivity graphite foam meets the conductivity requirements, so we thought: why not combine the two?”
The porous graphite foam traps the salts in pores, facilitating rapid melting and freezing. The team demonstrated that this rapid phase change holds up over time. After building and testing an initial prototype about the size of a blender, the team is now scaling up the prototype size by 50 times.
Although still smaller than a full-scale power plant system, the pilot-scale modular system will be tested this fall and could expand on applications, such as providing back-up power on a microgrid or storing waste heat from another energy source. The pilot system will also further improve 3-D thermal modeling used for estimating performance and planning the design of a full-scale system.
“We are looking at developing the full-scale power plant system as a modular system, and the pilot-scale system we are building this year can actually be used as one module within a full-scale system that is made of many modules stacked or organized together,” said Argonne mechanical engineer Wenhua Yu. “Therefore, the performance characteristics we will measure from testing the pilot can directly reflect those of a power plant system.”
The full-scale design is expected to meet the needs of current power plants that operate steam turbines at about 450 to 600 degrees Celsius (850-1100 degrees Fahrenheit) using magnesium chloride as the storage medium. When advanced supercritical carbon dioxide turbines — which are more efficient than steam turbines but operate at a hotter 700 degrees Celsius (1,300 degrees Fahrenheit) — come online, the same design can be used with sodium chloride.
This work is supported by the DOE SunShot Initiative.
The SunShot Initiative is a collaborative national effort that aggressively drives innovation to make solar energy fully cost-competitive with traditional energy sources before the end of the decade. Through SunShot, the DOE supports efforts by private companies, universities, and national laboratories to drive down the cost of solar electricity to $0.06 per kilowatt-hour. Learn more at energy.gov/sunshot.
About Argonne National Laboratory
Argonne National Laboratory seeks solutions to pressing national problems in science and technology. The nation's first national laboratory, Argonne conducts leading-edge basic and applied scientific research in virtually every scientific discipline. Argonne researchers work closely with researchers from hundreds of companies, universities, and federal, state and municipal agencies to help them solve their specific problems, advance America's scientific leadership and prepare the nation for a better future. With employees from more than 60 nations, Argonne is managed by UChicago Argonne, LLC for the U.S. Department of Energy's Office of Science.
Suggested Items
RTX Introduces the Collins Airport Surface Awareness System
05/10/2024 | RTXCollins Aerospace, an RTX business, introduces Collins’ Airport Surface Awareness System for real-time tracking, monitoring, and recording of both aircraft and ground support equipment at airports.
Airbus Finalises Acquisition of Aerovel and Its UAS Flexrotor
05/10/2024 | AirbusAirbus has finalised the acquisition of U.S.-based Aerovel and its unmanned aerial system (UAS), Flexrotor, in a move to strengthen its portfolio of tactical unmanned solutions.
Lockheed Martin Receives $451M to Upgrade Additional US Army and International M270 Launchers
05/10/2024 | Lockheed MartinThe U.S. Army awarded Lockheed Martin a $451 million contract to recapitalize additional M270 systems expanding its domestic fleet of launchers and providing upgrades for global partners.
BAE Systems and Eaton Expand Collaboration to Deliver Electric Drive Solutions for Heavy-Duty Trucks
05/08/2024 | PRNewswireBAE Systems, a leader in electric propulsion, and Eaton, a global power management company, are expanding their collaboration to include electric vehicle (EV) solutions for heavy-duty trucks.
OSI Systems Receives $6 Million Order for Electronic Assemblies
05/08/2024 | BUSINESS WIREOSI Systems, Inc. announced that its Optoelectronics and Manufacturing division has received an order for approximately $6 million to provide electronic assemblies to an advanced engineered solutions OEM.