-
- News
- Books
Featured Books
- pcb007 Magazine
Latest Issues
Current IssueAdvancing the Advanced Materials Discussion
Moore’s Law is no more, and the advanced material solutions to grapple with this reality are surprising, stunning, and perhaps a bit daunting. Buckle up for a dive into advanced materials and a glimpse into the next chapters of electronics manufacturing.
Inventing the Future With SEL
Two years after launching its state-of-the-art PCB facility, SEL shares lessons in vision, execution, and innovation, plus insights from industry icons and technology leaders shaping the future of PCB fabrication.
Sales: From Pitch to PO
From the first cold call to finally receiving that first purchase order, the July PCB007 Magazine breaks down some critical parts of the sales stack. To up your sales game, read on!
- Articles
- Columns
- Links
- Media kit
||| MENU - pcb007 Magazine
Estimated reading time: 1 minute

Contact Columnist Form
Trouble in Your Tank: Via Formation and Drilling Mechanics, Part 1
Introduction
In the extensive process of printed circuit board fabrication, one of the steps involves mechanically drilling through-hole vias. Via formation is then followed by desmear and metallization. The quality of the through-hole drilling process (and by inference the quality of the drilled through-hole) or lack thereof will also impact the desmear and metalization processes. While drilling equipment, tools and methods have been continually improved over the years, the fabricator must adhere to strict guidelines with respect to maintenance of the equipment, quality of the drill bits, the drilling operation parameters as well as the proper selection and use of entry and back-up materials. When simple maintenance of drill equipment and drill bits is lacking, drilled hole wall quality deteriorates. This then leads to defects in the PTH that are not attributable to the plating processes such as electroless copper. However, for this month’s edition of “Trouble in Your Tank,” I will present some of the basics of drilling.
Drilling Basics
Through-holes are formed by the cutting action of drill bits in numerically-controlled drilling machines. Figure 1 shows a five-head drilling machine. There are multiple factors to consider when mechanically drilling plated through-holes as well as blind and buried vias (assuming mechanical drilling will be used on a few applications for blind/buried vias). These include the drill machine, drill bits, entry and back-up materials, drilling parameters, stack heights, etc. In addition, the type of resin that makes up the circuit board, along with glass weave style and content, will play a role in via drilling quality. This will be the subject of a future column of “Trouble in Your Tank.”
To read this entire article, which appeared in the November 2016 issue of The PCB Magazine, click here.
More Columns from Trouble in Your Tank
Trouble in Your Tank: Implementing Direct Metallization in Advanced Substrate PackagingTrouble in Your Tank: Minimizing Small-via Defects for High-reliability PCBs
Trouble in Your Tank: Metallizing Flexible Circuit Materials—Mitigating Deposit Stress
Trouble in Your Tank: Can You Drill the Perfect Hole?
Trouble in Your Tank: Yield Improvement and Reliability
Trouble in Your Tank: Causes of Plating Voids, Pre-electroless Copper
Trouble in Your Tank: Organic Addition Agents in Electrolytic Copper Plating
Trouble in Your Tank: Interconnect Defect—The Three Degrees of Separation