Dan's Biz Bookshelf: 'Revenge of the Tipping Point'
Marcy's Musings: Engineering Economics
Punching Out: Should You Sell Your Company to a Private Equity Firm?
FKN Systek Singulates Thin V-scored Panels with Close Component Spacing
November 22, 2022 | FKN SystekEstimated reading time: Less than a minute
Singulating .032” pre-scored PCBs can be problematic on standard depanelizers because the boards tend to flex when placed between cutting blades. Due to the symmetrical design of the blades and the extra stiffness given to the circular blade by using two bearings, this problem is largely eliminated when using the K7000 for separating thin PCB panels.
The 12” (304 mm) long linear blade has a .030" (.762 mm) thin symmetrical cutting edge designed particularly for PCBs with closely spaced components. The circular blade is 3.8" (71 mm) in diameter and has the same cutting edge profile as the linear blade. -- .030" (.762 mm) This blade is mounted on a shaft with the center line of the cutting blade passing directly through the middle of the support bearings.
The operator places the score-line on the linear blade and pulls the circular blade carriage across the upper score-line to safely singulate a panel. Weighing in at under 20 lbs and with a footprint of 21” wide and 13” deep the K7000 is easily transportable.
Share on:
Suggested Items
Sat Nusapersada Chooses Siemens' Process Preparation Software to Boost NPI and SMT Line Efficiency
11/21/2024 | Siemens Digital Industries SoftwareSiemens Digital Industries Software announced that Sat Nusapersada, one of the largest Electronics Manufacturing Services (EMS) providers in Indonesia, has adopted its Process Preparation software to reduce its timescale for New Product Introduction (NPI) of printed circuit board assemblies and improve the efficiency of its Surface Mount Technology production lines by 23 percent.
Beyond Design: High-speed Rules of Thumb
11/21/2024 | Barry Olney -- Column: Beyond DesignThe idiom “rule of thumb” is often used in electronics design and has its origins in the practice of measuring roughly with one’s thumb. Rules of thumb are easy-to-remember, broadly accurate guides or principles based on practice rather than theory. They are used to help feed our intuition to find a quick solution based on experience. We are often forced to use rules of thumb in PCB design in the absence of expensive analysis tools. We also use them to get quick ballpark figures initially and then fine-tune the numbers with further analysis. We can use rules of thumb as a sanity check to assess whether we are using our tools correctly. In this month’s column, I will present some commonly used and helpful rules for high-speed PCB design.
Yamaha Robotics Brings Inspection Innovations for Growing Markets to electronica 2024
11/19/2024 | Yamaha Robotics SMT SectionYamaha Robotics SMT section presented innovations in high-speed surface-mount inspection at electronica 2024, demonstrating the latest AI skills and special features for applications including LED lighting, e-mobility, and mechatronics.
IPC Introduces First Standard for In-Mold Electronics
11/18/2024 | IPCIPC announces the release of IPC-8401, Guidelines for In-Mold Electronics. IPC-8401 addresses in-mold electronics (IME) technology, providing industry consensus on guidelines for manufacturing processes, part structures, material selection, and production test methods to integrate printed electronics and components into 3D smart structures.
India’s Wearable Device Market Dropped 20.7% in 3Q24
11/18/2024 | IDCAccording to International Data Corporation’s (IDC) India Monthly Wearable Device Tracker, India's wearable device market declined for the second consecutive quarter by 20.7% year-over-year (YoY) to 38 million units.