Dan’s Biz Bookshelf: The Ten Faces of Innovation
It’s Only Common Sense: Be the Solution, Not the Problem
American Made Advocacy: Long-time Challenges Confront a New Administration
BOOK EXCERPT: The Printed Circuit Designer’s Guide to... DFM Essentials, Introduction
October 16, 2024 | I-Connect007 Editorial TeamEstimated reading time: 1 minute
Introduction
One of the biggest challenges facing printed circuit board designers is properly understanding the cost drivers in the PCB manufacturing process, particularly the manufacturing of advanced technology PCBs.
Design for Manufacturing (DFM) is defined as the practice of designing printed circuit boards that meet not only the capabilities of the customer’s assembly manufacturing process, but also the capabilities of the board fabrication process to provide the highest reliability at the lowest possible cost.
The guidelines offered in this book are based on both ASC recommendations and IPC standards and apply to standard to advanced technology PCBs. UHDI technology may require violating many of the guidelines included within. It is also understood that some of these guidelines may require adjustment based on the material set, fabricator processes, and other design constraints.
While not a substitute for early design engagement with the PCB fabricator, in this book the reader will learn about these cost drivers (from the PCB manufacturer’s perspective) and the design decisions that will impact product reliability and help companies “design for success.”
Visit the I-Connect007 library to continue reading The Printed Circuit Designer’s Guide to DFM Essentials.
Share on:
Suggested Items
Quest Global Acquires Alpha-Numero Technology Solutions
03/14/2025 | Quest GlobalQuest Global is pleased to announce the acquisition of Alpha-Numero Technology Solutions. Alpha-Numero is a US-based VLSI design company with expertise in FPGA.
Würth Elektronik Now an Infineon ‘Preferred Partner’
03/13/2025 | Wurth Elektronik eiSosWürth Elektronik, one of the leading manufacturers of electronic and electromechanical components, is broadening its collaboration with semiconductor manufacturers.
Elementary Mr. Watson: Ensuring a Smooth Handoff From PCB Design to Fabrication
03/13/2025 | John Watson -- Column: Elementary, Mr. WatsonAt the 2020 Tokyo Summer Olympics, the U.S. men's 4x100-meter relay team had high hopes of winning a medal. The team comprised some of the fastest sprinters in the world, but something went wrong. In a relay, four runners must smoothly pass their baton to the next runner inside a zone on the track. If a runner drops the baton or it’s passed outside the zone, the team risks disqualification. The U.S. team’s pass between the second and third runner was messy, slowing them down. By the time the last runner received the baton, the team had lost too much time. They finished sixth in their heat and didn’t qualify for the final.
Ventec International Group Announce Launch of VT-47LT IPC4101 /126 Prepreg for HDI
03/12/2025 | Ventec International GroupVentec International Group announce launch of VT-47LT IPC4101 / 126 Prepreg. Are Microvia Failures Plaguing Your HDI Any Layer Designs? High-density interconnect (HDI) designs are pushing the envelope - higher layer count HDI relies on complex microvia designs: skip vias, staggered microvias, and stacked microvias in sequential laminations.
TI Introduces the World's Smallest MCU, Enabling Innovation in the Tiniest of Applications
03/12/2025 | PRNewswireTexas Instruments (TI) introduced the world's smallest MCU, expanding its comprehensive Arm® Cortex®-M0+ MSPM0 MCU portfolio. Measuring only 1.38mm2, about the size of a black pepper flake, the wafer chip-scale package (WCSP) for the MSPM0C1104 MCU enables designers to optimize board space in applications such as medical wearables and personal electronics, without compromising performance.