-
- News
- Books
Featured Books
- pcb007 Magazine
Latest Issues
Current IssueEngineering Economics
The real cost to manufacture a PCB encompasses everything that goes into making the product: the materials and other value-added supplies, machine and personnel costs, and most importantly, your quality. A hard look at real costs seems wholly appropriate.
Alternate Metallization Processes
Traditional electroless copper and electroless copper immersion gold have been primary PCB plating methods for decades. But alternative plating metals and processes have been introduced over the past few years as miniaturization and advanced packaging continue to develop.
Technology Roadmaps
In this issue of PCB007 Magazine, we discuss technology roadmaps and what they mean for our businesses, providing context to the all-important question: What is my company’s technology roadmap?
- Articles
- Columns
Search Console
- Links
- Media kit
||| MENU - pcb007 Magazine
Estimated reading time: 1 minute
Contact Columnist Form
Achieving Fine Lines and Spaces, Part 1
Circuit designs with three-mil lines and spaces are increasingly becoming the norm for high-layer multilayer fabrication and IC substrate technology. Regardless of one’s technology level, optimizing the imaging process should be of paramount concern. Over the next few months, I will present the critical steps in the imaging process and again provide insight as to where potential yield reducing defects can occur and how to prevent them. This month I will first approach the all-important surface preparation step prior to resist lamination.
Getting Surface Preparation Right
Consider the job that the photoresist must accomplish. Besides the fact that it must provide the optimum photospeed and the highest resolution, the resist must adhere to the copper surface in order prevent resist lifting during the developing and etching steps. How does one accomplish this? First, we have to get the surface preparation prior to resist lamination.
Now, consider the copper foil surface. For this particular column, we will focus on innerlayer copper foils rather than outer layers. For innerlayers, the fabricator must carefully prepare the copper surface in order to enhance the adhesion of the photoresist during the lamination process and prior to exposure and development. It is an accepted belief that resist adhesion to copper surface depends on two very critical factors:
- Overall cleanliness of the copper surface and
- Film contact area.
Read the full column here.
Editor's Note: This column originally appeared in the November 2013 issue of The PCB Magazine.
More Columns from Trouble in Your Tank
Trouble in Your Tank: Interconnect Defect—The Three Degrees of SeparationTrouble in Your Tank: Things You Can Do for Better Wet Process Control
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 5
Trouble in Your Tank: Materials for PWB Fabrication—Drillability and Metallization
Trouble in Your Tank: Supporting IC Substrates and Advanced Packaging, Part 5
Trouble in Your Tank: Electrodeposition of Copper, Part 6
Trouble in Your Tank: Electrolytic Copper Plating, Part 5
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 4