Global Citizenship: Comparing and Contrasting the U.S. and China PCB Industries
Standard of Excellence: Finding and Hiring the Right Candidates for Engineering Positions
Global Sourcing Spotlight: 10 Rules of the Game
FKN Systek Singulates Thin V-scored Panels with Close Component Spacing
November 22, 2022 | FKN SystekEstimated reading time: Less than a minute
Singulating .032” pre-scored PCBs can be problematic on standard depanelizers because the boards tend to flex when placed between cutting blades. Due to the symmetrical design of the blades and the extra stiffness given to the circular blade by using two bearings, this problem is largely eliminated when using the K7000 for separating thin PCB panels.
The 12” (304 mm) long linear blade has a .030" (.762 mm) thin symmetrical cutting edge designed particularly for PCBs with closely spaced components. The circular blade is 3.8" (71 mm) in diameter and has the same cutting edge profile as the linear blade. -- .030" (.762 mm) This blade is mounted on a shaft with the center line of the cutting blade passing directly through the middle of the support bearings.
The operator places the score-line on the linear blade and pulls the circular blade carriage across the upper score-line to safely singulate a panel. Weighing in at under 20 lbs and with a footprint of 21” wide and 13” deep the K7000 is easily transportable.
Share on:
Suggested Items
Northrop Grumman’s Deep Sensing and Targeting Technology Goes Airborne to Advance Vision for the US Army
10/22/2024 | Northrop GrummanPhase two of Northrop Grumman Corporation’s Deep Sensing and Targeting (DSaT) system was successfully demonstrated at Vanguard 24, an annual capstone experiment hosted by the U.S. Army. DSaT gathers space-based data for long-range precision fires while airborne, helping bridge specific capability gaps and future warfighting requirements by expanding mission effectiveness and standoff range for Army platforms.
BOOK EXCERPT: The Printed Circuit Designer’s Guide to... DFM Essentials, Introduction
10/16/2024 | I-Connect007 Editorial TeamDesign for Manufacturing (DFM) is defined as the practice of designing printed circuit boards that meet not only the capabilities of the customer’s assembly manufacturing process, but also the capabilities of the board fabrication process to provide the highest reliability at the lowest possible cost.
TopLine to Exhibit 'Drop-in Replacement' for BGA at Electronica
10/16/2024 | TopLineTopLine Corporation will exhibit its latest technology solutions at Electronica in Munich, Germany, November 12 – 15, 2024, in stand B4.428.
Increased Production and Weakened Demand to Drive NAND Flash Prices Down 3–8% in 4Q24
10/15/2024 | TrendForceTrendForce’s latest findings reveal that NAND Flash products have been impacted by weaker-than-expected seasonal demand in the second half of 2024, leading to a decline in wafer contract prices in Q3. This downward trend is projected to deepen, with prices expected to drop by more than 10% in Q4.
Gartner Says Worldwide PC Shipments Declined 1.3% in Third Quarter of 2024
10/14/2024 | Gartner, Inc.Worldwide PC shipments totaled 62.9 million units in the third quarter of 2024, a 1.3% decline from the third quarter of 2023, according to preliminary results by Gartner, Inc. This decline comes after three consecutive quarters of year-over-year growth for the PC market.