Robotic Device Improves Balance and Gait in Parkinson’s Disease Patients
December 27, 2017 | Columbia EngineeringEstimated reading time: 4 minutes
Columbia engineers find that a single session of perturbation-based training, using their Tethered Pelvic Assist Device, increased stability of patients during walking while exposed to unexpected perturbations.
Some 50,000 people in the U.S. are diagnosed with Parkinson's disease (PD) every year. The American Institute of Neurology estimates there are one million people affected with this neurodegenerative disorder, with 60 years as average age of onset. Falls and fall-related injuries are a major issue for people with Parkinson’s—up to 70% of advanced PD patients fall at least once a year and two-thirds suffer recurring falls. These fall rates are twice as high as those of adults of comparable age, so improving balance in patients with Parkinson’s would provide a major health advantage.
Sunil Agrawal, professor of mechanical engineering and of rehabilitation and regenerative medicine at Columbia Engineering, along with Dario Martelli, a post-doctoral researcher in his group, have been working on this issue with Movement Disorders faculty from the department of neurology at Columbia University Medical Center—Stanley Fahn, a leading expert in Parkinson’s, and Un Jung Kang, division director, and Movement Disorder Fellow Lan Luo. In their latest study, published this week in Scientific Reports, the team looked at whether or not Parkinson’s disease affects patients’ balance and diminishes their ability to react and adapt to walking with perturbations. The researchers found that the ability to adapt to multiple perturbations or to modify responses to changing amplitudes or directions was not affected by PD; both the Parkinson’s and the healthy subjects controlled their reactive strategies in the same way. In fact, both groups improved their unperturbed walking after a single training session with repeated waist pull perturbations.
Agrawal’s team, experts in rehabilitation robotics, used a robotic system—Tethered Pelvic Assist Device (TPAD)—invented in his Robotics and Rehabilitation (ROAR) Laboratory to perform the study. The TPAD is a wearable, lightweight cable-driven robot that can be programmed to provide forces on the pelvis in a desired direction as a subject walks on a treadmill. In an earlier study, Agrawal successfully used the TPAD to improve posture and walking in children with cerebral palsy.
“Most falls in PD are reported during walking, and gait disorders are one of the hallmarks of PD, but previous studies on PD subjects have focused on responses to balance perturbations only while standing,” says Agrawal, also a member of the Data Science Institute. “Our TPAD has enabled us for the first time to study how subjects respond to repeated pelvic perturbations during walking, and to characterize reactive and adaptive responses to these perturbations among the young, old, and PD patients.”
Nine PD patients and nine age-matched control subjects participated in the study. The researchers evaluated the margin of stability and base of support while the study participants walked without cables on a treadmill. Then the participants were hooked up to the TPAD’s cables and given waist-pull diagonal perturbations for brief periods to assess their reactions. Each group was then trained with 72 randomly applied pelvic force perturbations that varied in direction (forward/backward/sideways), intensity (low/medium/high), and the specific foot (right/left) in contact with the ground. After this training period, they walked freely without the cables and underwent the same diagonal perturbations they had been given before training. These post-sessions were conducted to assess the effects of training on their balance and stability.
The team found that the Parkinson’s patients had a reduced stability in the forward direction before and after training compared to the healthy subjects and an inability to produce proactive anticipatory adjustments. Once all the subjects completed the training session, both groups were able not only to improve their response to the perturbations, but also to produce short-term aftereffects of increased gait stability.
“Our data showed that one single session of perturbation-based balance training produced acute effects that ameliorated gait instability in PD patients,” says Martelli, the paper’s first author. “This result is encouraging for designing new therapeutic interventions that remediate falls risk.”
Falls often happen unexpectedly when someone fails to recover from a loss of balance.
While current training methods, such as conventional exercises at the gym, target volitional movements of the body, they do not address the specific neuromuscular skills required for fall prevention.
“This novel TPAD provides an insight into the specific mechanisms underlying the propensity of PD patients to fall and the ability to address these specific deficits to train them to avoid falls. The potential impact of such training to prevent accompanying morbidity from the falls and to improve their quality of life is great,” Kang says.
Fahn notes, “We believe that new training programs, in coordination with new robotic devices such as Columbia Engineering’s TPAD, should be developed where unexpected force perturbations are given to the human subjects in a controlled way that allows the human brain to develop control strategies to respond to these perturbations, maintain balance, and avoid falls.”
The researchers are now planning future studies to examine if a multi-session training program will demonstrate more lasting effects on walking balance, improve function, and reduce the number of falls in long-term assessments.
Testimonial
"In a year when every marketing dollar mattered, I chose to keep I-Connect007 in our 2025 plan. Their commitment to high-quality, insightful content aligns with Koh Young’s values and helps readers navigate a changing industry. "
Brent Fischthal - Koh YoungSuggested Items
Advint Incorporated Brings Artificial Intelligence to Electroplating Training
09/11/2025 | Advint IncorporatedAdvint Incorporated is introducing a new dimension to its electroplating training programs: the integration of Artificial Intelligence (AI). This initiative reflects the company’s commitment to providing PCB fabricators and manufacturers in the USA and Canada with training that is practical, forward-looking, and directly relevant to today’s production challenges.
Standard of Friendship: Debbie McDade and Symon Franklin Went From Classmates to Colleagues
08/27/2025 | Debbie McDade, Advanced Rework Technology Ltd.As a fairly new IPC Master Trainer, I nervously attended my first IPC committee meeting in 2002 in New Orleans—a 4,600-mile trip from my home in the UK—for the IPC-610 Task Group. With more than 250 members, it was the largest IPC committee at that time.
MS2 Technologies, LLC/P. Kay Focuses on Central America with First Installation in Honduras
08/24/2025 | P. Kay Metal, Inc.This year MS2 Technologies has turned their focused to the growing electronics market in Central America. With that focus came the adaptation of MS2 and the Akila System from a Honduras-based corporation with manufacturing plants in both Honduras and Mexico.
Meet with The Test Connection Inc. (TTCI) at SMTA Guadalajara 2025
08/18/2025 | The Test Connection Inc.The Test Connection Inc. (TTCI), a trusted provider of electronic test and manufacturing solutions for more than 45 years, is pleased to announce its participation at the upcoming SMTA Guadalajara Expo & Tech Forum, taking place September 17–18, 2025, at Expo Guadalajara, Salón Jalisco Hall D & E.
Creating Connections in Mexico
07/30/2025 | Michelle Te, Community MagazineA concerted effort by the Global Electronics Association—Mexico team over the past year has created inroads for the Global Electronics Association (formerly IPC) with leading electronics companies, government offices, and academic institutions in Mexico. “Our goal is to bring more awareness to what the Global Electronics Association is and what it offers,” says Lorena Villanueva, senior director. “We also aim to increase our membership. Of 3,200 members of the Global Electronics Association, only 180 are in Mexico.”