Reducing Print Cycle Time

Estimated reading time: 2 minutes

Of the several steps in the SMT process, an effective method of increasing throughput is to reduce the cycle time of the rate-controlling process step. Depending on the type of assembly and equipment set used, the process step with the longest cycle time could potentially be printing, solder paste inspection (SPI), component placement or reflow oven conveyor speed. This article will discuss two simple experiments that may lead to increased throughput and increased profitability (assuming the selling price exceeds the marginal cost of each assembly).

Print cycle time can be the bottleneck if the electronic assembly has relatively few components or if the production line used has a well equipped set of placement devices. If this is the case, there are two simple experiments that can be carried out to evaluate if a reduction in print cycle time can increase production volumes without reducing quality. Producing bad boards fast is much worse than producing good boards slowly. The first experiment is to increase the speed of the squeegee stoke. Figure 1 shows the relationship of the squeegee speed, stroke length and the time required for the solder paste to be printed.

Figure 1: Stroke time versus speed (inches per second) and distance.

If a slow squeegee speed is currently being used (<2 inches/second), there is a greater opportunity for increasing throughput. When running the experiment at increasing squeegee speeds, review the CpK recorded on your SPI equipment for a gain or reduction in process capability. Some solder pastes give better print volume reproducibility at higher speeds. This results in a win-win, higher production and improved process yields.

One important thing to look for when increasing the squeegee speed is paste left on the stencil. When a higher squeegee speed is used, it is usually necessary to increase the pressure of the blade on the stencil until the residue disappears.

The second experiment to reduce print process cycle time is to examine how often you clean the bottom side of the stencil. This is commonly referred to as wipe frequency. Cleaning the stencil removes solder paste that may be building up in the apertures. It also removes any paste that may be trapped under the stencil, waiting to be transfer printed to an undesired place on the circuit card, later to be blamed as a spatter.

Read The Full Article Here

Editor's Note: This article originally appeared in the October 2015 issue of SMT Magazine.