Laser Technique Promises Super-fast and Super-secure Quantum Cryptography
April 5, 2016 | University of CambridgeEstimated reading time: 3 minutes
A new method of implementing an ‘unbreakable’ quantum cryptographic system is able to transmit information at rates more than ten times faster than previous attempts.
Researchers have developed a new method to overcome one of the main issues in implementing a quantum cryptography system, raising the prospect of a useable ‘unbreakable’ method for sending sensitive information hidden inside particles of light.
By ‘seeding’ one laser beam inside another, the researchers, from the University of Cambridge and Toshiba Research Europe, have demonstrated that it is possible to distribute encryption keys at rates between two and six orders of magnitude higher than earlier attempts at a real-world quantum cryptography system. The results are reported in the journal Nature Photonics.
Encryption is a vital part of modern life, enabling sensitive information to be shared securely. In conventional cryptography, the sender and receiver of a particular piece of information decide the encryption code, or key, up front, so that only those with the key can decrypt the information. But as computers get faster and more powerful, encryption codes get easier to break.
Quantum cryptography promises ‘unbreakable’ security by hiding information in particles of light, or photons, emitted from lasers. In this form of cryptography, quantum mechanics are used to randomly generate a key. The sender, who is normally designated as Alice, sends the key via polarised photons, which are sent in different directions. The receiver, normally designated as Bob, uses photon detectors to measure which direction the photons are polarised, and the detectors translate the photons into bits, which, assuming Bob has used the correct photon detectors in the correct order, will give him the key.
The strength of quantum cryptography is that if an attacker tries to intercept Alice and Bob’s message, the key itself changes, due to the properties of quantum mechanics. Since it was first proposed in the 1980s, quantum cryptography has promised the possibility of unbreakable security. “In theory, the attacker could have all of the power possible under the laws of physics, but they still wouldn’t be able to crack the code,” said the paper’s first author Lucian Comandar, a PhD student at Cambridge’s Department of Engineering and Toshiba’s Cambridge Research Laboratory.
However, issues with quantum cryptography arise when trying to construct a useable system. In reality, it is a back and forth game: inventive attacks targeting different components of the system are constantly being developed, and countermeasures to foil attacks are constantly being developed in response.
The components that are most frequently attacked by hackers are the photon detectors, due to their high sensitivity and complex design – it is usually the most complex components that are the most vulnerable. As a response to attacks on the detectors, researchers developed a new quantum cryptography protocol known as measurement-device-independent quantum key distribution (MDI-QKD).
In this method, instead of each having a detector, Alice and Bob send their photons to a central node, referred to as Charlie. Charlie lets the photons pass through a beam splitter and measures them. The results can disclose the correlation between the bits, but not disclose their values, which remain secret. In this set-up, even if Charlie tries to cheat, the information will remain secure.
MDI-QKD has been experimentally demonstrated, but the rates at which information can be sent are too slow for real-world application, mostly due to the difficulty in creating indistinguishable particles from different lasers. To make it work, the laser pulses sent through Charlie’s beam splitter need to be (relatively) long, restricting rates to a few hundred bits per second (bps) or less.
The method developed by the Cambridge researchers overcomes the problem by using a technique known as pulsed laser seeding, in which one laser beam injects photons into another. This makes the laser pulses more visible to Charlie by reducing the amount of ‘time jitter’ in the pulses, so that much shorter pulses can be used. Pulsed laser seeding is also able to randomly change the phase of the laser beam at very high rates. The result of using this technique in a MDI-QKD setup would enable rates as high as 1 megabit per second, representing an improvement of two to six orders of magnitude over previous efforts.
“This protocol gives us the highest possible degree of security at very high clock rates,” said Comandar. “It could point the way to a practical implementation of quantum cryptography.”
Suggested Items
Stan Rak: Elevating the Ideas and Insights of IPC's Thought Leaders Program
04/25/2024 | Stanton Rak, SF Rak CompanyAs a member of the IPC Thought Leaders Program (TLP), I am responsible for identifying knowledge-sharing opportunities that can generate ideas and insights that strengthen the IPC community as well as create a sustainable and lasting future for its members. I am delighted to highlight some of my recent contributions as a member of the TLP.
indie Semiconductor Launches Advanced Smart Connectivity Solutions for In-Cabin Applications
04/23/2024 | indie Semiconductorindie Semiconductor, Inc., an Autotech solutions innovator, has introduced a family of new high-performance video converters and retimers to enable in-cabin connectivity applications, including audio and video transport and device interfacing.
The Need for a Holistic Global Sustainability Standard
04/10/2024 | Michael Ford, Aegis SoftwareNo one can deny that the resources of our fragile planet are finite. The environment seems like a third party, subject to constant degradation. We’re acutely aware of the effects of pollution on our climate, and despite our “throw-away” culture, recycling and recovery of materials has remained relatively expensive, even as we use more energy just to survive.
Technica Leads the Way Into Automation and Machine Learning at IPC APEX EXPO 2024
03/28/2024 | Marcy LaRont, PCB007 MagazineAs a significant partner to PCB fabricators since almost the beginning of multilayer boards, Technica USA brings a lot of expertise to the industry. This year’s IPC APEX EXPO show will showcase their biggest booth yet, and a whole lot of information, discussion and demonstration around automation and AI machine learning. In this interview, Jason Perry discusses Technica's plans for the show, and why attendees should stop by.
Airbus to Acquire INFODAS and Strengthen its Cybersecurity Portfolio
03/25/2024 | AirbusAirbus Defence and Space has entered into an agreement to acquire INFODAS, a Cologne-based, German company that provides cybersecurity and IT solutions in the public sector including for defence and critical infrastructures.