Dan’s Biz Bookshelf: ‘Elevate: Push Beyond Your Limits'
The Marketing Minute: The First Step to More Sales—Marketing
It’s Only Common Sense: Customer Service Is Sales in Disguise
atg Luther & Maelzer and IEC Install A7Pro Flying Probe Tester at Toronto-based PCB Factory
February 19, 2024 | IECEstimated reading time: Less than a minute
Longest-serving distributor to the North American PCB industry, IEC (International Electronic Components) confirms that the atg Luther & Maelzer A7Pro, eight-head, double-sided, high-speed flying probe test system has been ordered and installed at a prominent PCB manufacturer in Toronto, Canada.
IEC President Shawn Stone says, “IEC attributes our longevity to the expertise and dedication of our sales team leaders, our loyal customers, and strategic partners such as atg Luther & Maelzer.”
atg’s A7Pro testers utilize eight flying probe test heads, multiple optical recognition systems, and a wide variety of advanced, high-speed electrical test measurement techniques to electrically test all types of PCBs for continuity and isolation. Board sizes of 24" x 21" (or larger), with small pad/fine pitch technology can be tested quickly and easily. Special options such as 4-wire Kelvin tests, hi-pot test, latent defect test, and others can be provided.
Share on:
Suggested Items
TRI to Exhibit at SMTA Queretaro Expo 2025
07/16/2025 | TRITest Research, Inc. (TRI), the leading provider of test and inspection systems for the electronics manufacturing industry, is pleased to announce plans to exhibit at the SMTA Querétaro Expo 2025, scheduled to take place on July 24, 2025, at the Querétaro Centro de Congresos y Teatro Metropolitano.
Knocking Down the Bone Pile: Addressing End-of-life Component Solderability Issues, Part 4
07/16/2025 | Nash Bell -- Column: Knocking Down the Bone PileIn 1983, the Department of Defense identified that over 40% of military electronic system failures in the field were electrical, with approximately 50% attributed to poor solder connections. Investigations revealed that plated finishes, typically nickel or tin, were porous and non-intermetallic.
Meet the Author Podcast: Martyn Gaudion Unpacks the Secrets of High-Speed PCB Design
07/16/2025 | I-Connect007In this special Meet the Author episode of the On the Line with… podcast, Nolan Johnson sits down with Martyn Gaudion, signal integrity expert, managing director of Polar Instruments, and three-time author in I-Connect007’s popular The Printed Circuit Designer’s Guide to... series.
TTCI Joins Printed Circuit Engineering Association to Strengthen Design-to-Test Collaboration and Workforce Development
07/09/2025 | The Test Connection Inc.The Test Connection Inc. (TTCI), a leading provider of electronic test and manufacturing solutions, is proud to announce its membership in the Printed Circuit Engineering Association (PCEA), further expanding the company’s efforts to support cross-functional collaboration, industry standards, and technical education in the printed circuit design and manufacturing community.
Study on Resonance Mitigation in Metallic Shielding for Integrated Circuits
07/08/2025 | Maria Cuesta-Martin, Victor Martinez, Vidal Gonzalez Aguado, Würth ElektronikInherent cavity resonant modes often lead to significant degradation of shielding effectiveness, responsible for unwanted electromagnetic coupling. Cavity resonant modes of the metal shielding enclosure can produce two adverse problems: the mutual coupling among different RF modules and shielding effectiveness reduction of the metal enclosure. The cabinets serve to shield certain components from electromagnetic interference (EMI). However, these cavities present some resonance peaks at 5 GHz, making it impossible to use them at higher frequencies.