Knocking Down the Bone Pile: Gold Mitigation for Class 2 Electronics
Punching Out: Your Financial Preparation for a Sale
Nolan's Notes: The Next Killer App in Component Manufacturing
Are Regional Differences in PCB Technology as Great as We Think?
May 24, 2019 | Denny Fritz, Fritz ConsultingEstimated reading time: 1 minute
We keep hearing that Asia is all consumer and automotive electronics and North America and Europe are all high reliability/long life. The findings in IPC’s PCB Technology Trends 2018 study show that these regions are not as different as expected, and the differences we do see are interesting.
There are small differences in rigid board layers, line widths and materials. A bigger difference shows up in flexible circuits where there is more low-layer count flex going into consumer electronics. True, North America and Europe have more rigid construction boards going into long-life (11 to 25+ years) products, pushing reliability. HDI construction is larger in Asia, as expected, but certainly not unknown in North America and Europe.
North American and European OEMs specified significantly more buried vias than Asia. This could reflect either better acceptance of sub-laminations or more “any layer via” construction(not needing sub-laminations) in Asia. But, as Asia produces eight times as many boards as North America and Europe, Asian fabrication is quite capable of meeting the buried via needs of the other regions.
The study also shows that investment in direct imaging and AOI are the top two capital equipment investment priorities of the industry in both regions for the next two years. Likewise, reliability and cost were the top two technical challenges for the industry in both regions.
Are these findings consistent with your experiences of making or specifying PCBs in different regions? Do you think the regional differences are getting smaller? We welcome your comments.
Share on:
Suggested Items
Intervala Hosts Employee Car and Motorcycle Show, Benefit Nonprofits
08/27/2024 | IntervalaIntervala hosted an employee car and motorcycle show, aptly named the Vala-Cruise and it was a roaring success! Employees had the chance to show off their prized wheels, and it was incredible to see the variety and passion on display.
KIC Honored with IPC Recognition for 25 Years of Membership and Contributions to Electronics Manufacturing Industry
06/24/2024 | KICKIC, a renowned pioneer in thermal process and temperature measurement solutions for electronics manufacturing, is proud to announce that it has been recognized by IPC for 25 years of membership and significant contributions to electronics manufacturing.
Boeing Starliner Spacecraft Completes Successful Crewed Docking with International Space Station
06/07/2024 | BoeingNASA astronauts Barry "Butch" Wilmore and Sunita "Suni" Williams successfully docked Boeing's Starliner spacecraft to the International Space Station (ISS), about 26 hours after launching from Cape Canaveral Space Force Station.
KIC’s Miles Moreau to Present Profiling Basics and Best Practices at SMTA Wisconsin Chapter PCBA Profile Workshop
01/25/2024 | KICKIC, a renowned pioneer in thermal process and temperature measurement solutions for electronics manufacturing, announces that Miles Moreau, General Manager, will be a featured speaker at the SMTA Wisconsin Chapter In-Person PCBA Profile Workshop.
The Drive Toward UHDI and Substrates
09/20/2023 | I-Connect007 Editorial TeamPanasonic’s Darren Hitchcock spoke with the I-Connect007 Editorial Team on the complexities of moving toward ultra HDI manufacturing. As we learn in this conversation, the number of shifting constraints relative to traditional PCB fabrication is quite large and can sometimes conflict with each other.