Facing the Future: The Role of 5G and Beyond in Shaping PCB Demand
It’s Only Common Sense: Stop Pitching, Start Listening
Trouble in Your Tank: Causes of Plating Voids, Pre-electroless Copper
US Economy Continues Decent Growth Pace
July 26, 2019 | The Conference BoardEstimated reading time: 1 minute
At 2.1%, the growth of US Real Gross Domestic Product during the second quarter of 2019 comes out better than expected. The weakness observed at the end of 2018 and early 2019, which was underlined by revised estimates for earlier quarters, has been wiped out especially by very strong consumption growth at 4.3% in Q2.
However, the strength of the economy is rather unbalanced. The growth rate of investment was negative across the board, except for technology investments. Combined with a decline in exports, largely due to weaknesses elsewhere in the global economy, this report suggests growth to retain its strength at just over 2% for the second half of 2019.
This report is unlikely to influence the FOMC decision making process next week which is likely to lead to a slight reduction in the Federal Fund rate, especially given the underperformance of investment and global uncertainties. But going forward, if the US economy maintains its growth rate above 2%, it could moderate the appetite for further cuts later in the year.
About The Conference Board
The Conference Board is the member-driven think tank that delivers trusted insights for what’s ahead. Founded in 1916, we are a non-partisan, not-for-profit entity holding 501 (c) (3) tax-exempt status in the United States.
Share on:
Suggested Items
Rules of Thumb: Design007 Magazine, November 2024
11/11/2024 | I-Connect007 Editorial TeamRules of thumb are everywhere, but there may be hundreds of rules of thumb for PCB design. They’re built on design formulas, fabricators’ limitations, and tribal knowledge. And unfortunately, some longtime rules of thumb should be avoided at all costs. How do we separate the wheat from the chaff, so to speak?
Connect the Dots: Best Practices for Prototyping
09/21/2023 | Matt Stevenson -- Column: Connect the DotsPCB prototyping is a critical juncture during an electronic device’s journey from concept to reality. Regardless of a project’s complexity, the process of transforming a design into a working board is often enlightening in terms of how a design can be improved before a PCB is ready for full production.
The Drive Toward UHDI and Substrates
09/20/2023 | I-Connect007 Editorial TeamPanasonic’s Darren Hitchcock spoke with the I-Connect007 Editorial Team on the complexities of moving toward ultra HDI manufacturing. As we learn in this conversation, the number of shifting constraints relative to traditional PCB fabrication is quite large and can sometimes conflict with each other.
Asia/Pacific AI Spending Surge to Reach a Projected $78 Billion by 2027
09/19/2023 | IDCAsia/Pacific spending on Artificial Intelligence (AI) ), including software, services, and hardware for AI-centric systems will grow to $78.4 billion in 2027, according to International Data Corporation's latest Worldwide Artificial Intelligence Spending Guide.
Intel to Sell Minority Stake in IMS Nanofabrication Business to TSMC
09/13/2023 | IntelIntel Corporation announced that it has agreed to sell an approximately 10% stake in the IMS Nanofabrication business to TSMC. TSMC’s investment values IMS at approximately $4.3 billion, consistent with the valuation of the recent stake sale to Bain Capital Special Situations.