-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueCreating a Culture of Collaboration
PCB designers could learn quite a bit from NASA and the private companies that develop spacecraft: Every one of these vehicles is a testament to the value of collaboration among disparate stakeholders. Without a collaborative culture, the rocket might never get off the ground.
Breaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
DDR3/4 Fly-by Topology Termination and Routing
DDR3/4 fly-by topology is similar to daisy chain or multi-drop topology, but it includes very short stubs to each memory device in the chain to reduce the reflections. The advantage of fly-by topology is that it supports higher-frequency operation and improves signal integrity and timing on heavily loaded signals. If you are employing high-frequency DDR4, then the bandwidth of the channel needs to be as high as possible. However, with today’s extremely fast edge rates, the sequencing of the stubs and the end termination, and the associate load, can make a measurable difference in signal quality. In this month’s column I will look at how best to route DDR3/4 fly-by topology.
Reflections occur whenever the impedance of the transmission line changes along its length. This can be caused by unmatched drivers/loads, layer transitions, different dielectric materials, stubs, vias, connectors, terminations and IC packages. By understanding the causes of these reflections and eliminating the source of the mismatch, a design can be engineered with reliable performance. For perfect transfer of energy and to eliminate reflections, the impedance of the source must equal the impedance of the trace, as well as the impedance of the load.
As signal rise times increase, consideration should be given to the propagation time and reflections of a routed trace. If the propagation time and reflection from source to load are longer than the edge transition time, an electrically long trace will exist. If the transmission line is short, reflections still occur but will be overwhelmed by the rising or falling edge and may not pose a problem. But even if the trace is short, termination may still be required if the load is capacitive or highly inductive to prevent ringing.
Series termination is an excellent strategy for point-to-point routes, one load per net. Whereas parallel (end termination), is preferred for busses with a number of loads in a multi-drop topology. For DDR3/4 layouts, a series termination is generally not required for on-board memory devices. However, if your design has plug-in memory then the data and data mask signal length may be excessive and require a series termination.
To read this entire column, which appeared in the June 2018 issue of Design007 Magazine, click here.
More Columns from Beyond Design
Beyond Design: Dielectric Material Selection GuideBeyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities