Target Condition: Distribution of Power—Denounce the Ounce
Fresh PCB Concepts: Resilience and Renewal in Domestic PCB Manufacturing
Designers Notebook: Power and Ground Distribution Basics
Survey: Complete, Accurate Design Data Tops List of Fab Expectations
April 30, 2020 | I-Connect007 Research TeamEstimated reading time: Less than a minute
In a recent survey, we asked PCB designers about expectations, particularly fabricators’ expectations of their PCB designer customers. The overwhelming majority (84%) of respondents indicated that a fabricator’s primary expectation of a designer is a complete, accurate data package.
A handful of respondents (6%) cited a solid understanding of the fabrication process, while even fewer (4%) said that fabricators expected frequent communication with their design customers.
Here are some of the survey comments, edited slightly for clarity:
- “A complete and accurate data package is high on the list. Getting an approved stackup is another. Using the right trace and space rules for finished copper thickness. Basically, they expect us to provide a package that can be fabricated using their process that is not pushing the boundaries on every item.”
- “Timely, correct, and cooperative feedback on issues discovered with a job.”
- “Designers must be expert at managing and implementing high-speed design rules.”
- “Fabricators expect us to have frequent communications.”
- “A full, detailed manufacturing package, including special requirements.”
Share on:
Testimonial
"In a year when every marketing dollar mattered, I chose to keep I-Connect007 in our 2025 plan. Their commitment to high-quality, insightful content aligns with Koh Young’s values and helps readers navigate a changing industry. "
Brent Fischthal - Koh YoungSuggested Items
Trouble in Your Tank: Understanding Interconnect Defects, Part 1
11/04/2025 | Michael Carano -- Column: Trouble in Your TankThis month, I’ll address interconnect defects (ICDs). While this defect continues to rear its ugly head, don’t despair. There are solutions, most of which center on process control and understanding the relationship of the chemistry, materials, and equipment. First, though, let’s discuss ICDs.
Target Condition: Distribution of Power—Denounce the Ounce
11/05/2025 | Kelly Dack -- Column: Target ConditionHave you ever wondered why the PCB design segment uses ounces to describe copper thickness? There’s a story behind all of this—a story that’s old, dusty, and more than a little absurd. (Note that I didn’t add “Like many of us.”) Legend has it that back in the days of copper tinkers and roofing tradesmen, the standard was set when a craftsman hammered out a sheet of copper until it weighed one ounce, when its area conveniently matched the square of the king’s foot.
WestDev Announces Advanced Thermal Analysis Integration for Pulsonix PCB Design Suite
10/29/2025 | WestDev Ltd.Pulsonix, the industry-leading PCB design software from WestDev Ltd., announced a major enhancement to its design ecosystem: a direct interface between Pulsonix and ADAM Research's TRM (Thermal Risk Management) analysis software.
Designers Notebook: Power and Ground Distribution Basics
10/29/2025 | Vern Solberg -- Column: Designer's NotebookThe principal objectives to be established during the planning stage are to define the interrelationship between all component elements and confirm that there is sufficient surface area for placement, the space needed to ensure efficient circuit interconnect, and to accommodate adequate power and ground distribution.
Episode 6 of Ultra HDI Podcast Series Explores Copper-filled Microvias in Advanced PCB Design and Fabrication
10/15/2025 | I-Connect007I-Connect007 has released Episode 6 of its acclaimed On the Line with... American Standard Circuits: Ultra High Density Interconnect (UHDI) podcast series. In this episode, “Copper Filling of Vias,” host Nolan Johnson once again welcomes John Johnson, Director of Quality and Advanced Technology at American Standard Circuits, for a deep dive into the pros and cons of copper plating microvias—from both the fabricator’s and designer’s perspectives.