-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueSilicon to Systems: From Soup to Nuts
This month, we asked our expert contributors to weigh in on silicon to systems—what it means to PCB designers and design engineers, EDA companies, and the rest of the PCB supply chain... from soup to nuts.
Cost Drivers
In this month’s issue of Design007 Magazine, our expert contributors explain the impact of cost drivers on PCB designs and the need to consider a design budget. They discuss the myriad design cycle cost adders—hidden and not so hidden—and ways to add value.
Mechatronics
Our expert contributors discuss the advent of mechatronics in PCB design, the challenges and opportunities this creates for circuit board designers, and the benefits—to the employee and the company—of becoming a mechatronics engineer.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
![](https://iconnect007.com/application/files/2416/3116/1073/barry_olney300.jpg)
Material Selection for Digital Design
In a previous column, Material Selection for SERDES Design, I pointed out that materials used for the fabrication of the multilayer PCB absorb high frequencies and reduce edge rates and that loss, in the transmission lines, is a major cause of signal integrity issues. But we are not all designing cutting-edge boards, and sometimes we tend to over-specify requirements that can lead to inflated production costs.
In this column, I will look at what types of materials are commonly used for digital design, and how to select an adequate material to minimize costs. Of course, selecting the best possible material will not hurt, but it may blow out the costs.
Figure 1: Simulated signal propagating through a curved waveguide.
Signals propagate in a vacuum or air at approximately the speed of light. But, as the electromagnetic energy is enveloped in a dielectric material, sandwiched between planes in the PCB medium, it slows down. Figure 1 illustrates a signal propagating through a curved waveguide. This is representative of a typical stripline configuration of a PCB. What needs to be understood is that the signal traces on a PCB simply guide the signal wave, as the electromagnetic energy propagates in the surrounding dielectric material. It is the dielectric material that determines the velocity (v) of propagation of the electromagnetic energy:
Keep in mind that c is the speed of light (in free space) and Er is the dielectric constant of the material (FR-4 is ~4.0). By contrast, the Er of air is 1. Therefore, the velocity of propagation in FR-4 is about half the speed of light or 6 inches per ns. The important concept is that it is the electromagnetic energy that propagates down the transmission line--not electron flow. Electrons flow at about 0.4 inches per second, a snail’s pace by comparison.
Read the full column here.
Editor's Note: This column originally appeared in the August 2014 issue of The PCB Design Magazine.
More Columns from Beyond Design
Beyond Design: Does Current Deliver the Energy in a Circuit?Beyond Design: Termination Planning
Beyond Design: Dielectric Material Selection Guide
Beyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards